EVIL ENERGY 2.0 Inch Stainless Steel Exhaust Clamp - 2Pcs Lap Joint Band Clamp for Car, Truck & Motorcycle Exhaust Systems - High Temperature Resistant & Durable Performance

Good quality fit 3" outside to 3" inside diameter exhaust pipe. Polished.Does the job, until i get to the shop. Isn’t the best clamp but it’s okHeavy duty clamps that won't distort the pipes and while they hold real tight you can loosen to readjust countless times. No regrets here.This product was a great solution for repairing an exhaust pipe without having to replace the entire length of pipe. Saved money and time. Thank you!I have had Speed Engineering long tube headers on my 09 Silverado for a few years now, and I've always been disappointed by the low quality 1in wide band clamps that came with them. It wasn't until recently that I even thought to look for some better quality clamps that would actually seal up my exhaust and not sound like they had a small exhaust leak every time I started the truck up.I love how wide these clamps are and the fact that they overlap which will seal up the exhaust and prevent leaks. These are super easy to install and are so much better than welding your entire exhaust system, especially if you ever have to pull your transmission or do any major drivetrain repairs.So far I have had these on for a week and have no complaints. Time will tell how long they last and hold up to the repeated heating and cooling from daily driving.I've now used some Evil Energy AN fittings and they worked fine so I thought I would try these exhaust clamps. Make sure you know what you are ordering. This part number will connect 2 1/2 ID to 2 1/2 OD. Perfect for connecting your 2 1/2 exhaust pipe to your muffler without welding. Makes is so much easier to disassemble rather than fight with a welded joint. Now I just disconnect bolts at collector and loosen clamp at muffler and pull pipe out of the way. Good pricing too.I bought the 2" ID/OD connector. Fit was good. Clamps tightened up nicely. These are good for short term usage. I wouldn't trust them for long term usage as the metal is quite thin and once under tension may split if in an area where corrosion is a concern.These will need sealant or exhaust tape to make a 100% seal. The design of the clamp won't make a 100% seal. The amount of leakage depends whether you're using a slip joint or butt joint.When compared to a U clamp, they're much easier to use, allow for removal, less leakage. However, a U clamp will have a longevity advantage.Nice! Took a star off because as other reviewers stated, it feels cheap, not very thick. I like the guy that foil taped the exhaust and used the band clamp - that is probably going to last. This is a Walker replacement exhaust system for the 2008 T&C.Great clampsWhat can you say about them - they are clamps for an exhaust system.They work as intended to join a 2 1/2" ID pipe to a 2 1/2" OD pipe without welding allowing you to do a "driveway repair".The stainless steel was a little on the thin side, but it will do the job. Easy to use and fit well.Don't ever buy these clamps. They don't hold anything in place. Not 1 clamp tightened up properly. Every joint moved around. Good old fashion exhaust clamps did the job. Big time waste of $$$.good product , works very good , shipping was fast and on time